TM 5-3610-286-20
2-24.
Ink Fountain Assembly (cont).
(q) Install ink fountain roller handle (Sheet 2, 30) in threaded hole in ink fountain
clutch (7).
(r) Using bronze punch and ball-peen hammer, install woodruff key (31) in slot in ink
fountain roller (5) shaft.
(s) Slide clutch (32) onto ink roller shaft (5). Aline hole in top of
clutch (32) with pull rod (33) and bearing pins (34).
CAUTION
Use care in performing next step so as not to damage rigid lubrication lines
behind bearing pin.
(t)
(u)
(v)
(w)
(x)
Using wooden wedge, bronze punch, and ball-peen hammer, push bearing pin head
(34) so that bearing pin passes through hole in clutch far enough to expose several
threads on pin.
Install and tighten washer (35) and nut (36).
Install brake (37) on ink fountain roller shaft (5) so that brake extensions straddle brake
pin (38). Tighten brake screw (39).
Instaii cover plate (40) and two snap rings (41). Install flexible lubrication line fitting
(42) onto clutch (32).
Rotate ink fountain assembly (Sheet 2, 43) up and lock in place with star knobs
(Detail A-44).
CAUTION
Remove all wooden support blocks from press.
NOTE
FOLLOW-ON MAINTENANCE:
(1) Replace ink ductor roller (TM 5-3610-286-20).
(2) Adjust ink fountain roller stop spindles (TM 5-3610-286-20).
(3) Replace upper guard (O/S) (para. 2-18).
(4) Replace main guard (D/S) (para. 2-20).
2-120
