TM 5-3610-286-20
2-18.
Upper Guard and Accessories (O/S).
This task covers:
a. Remove
b. Repair
c. Install
INITIAL SETUP
Tools
Tools - cont.
3 mm pin punch
17 mm combination wrench
4 mm pin punch
1.0 x 1.6 x 0.5 mm flat-tip screwdriver
5 mm hex key
Retaining-ring pliers
8 mm hex key
Ball-peen hammer
a. Remove. (figure 2-15)
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(10)
(11)
(12)
(13)
Remove four form roller journal lock screws (1).
Remove retaining ring (2), spacer washer (3), handle (4), and spacer washer (5).
Remove spring tension pin (6), handle (7), and stud and compression spring (8).
Remove spring tension pin (9) and ink feed adjustment handwheel (10).
Remove spring tension pin (11), handle (12), and stud and compression spring (13).
Loosen hex nut (14) and remove handle (15).
Remove spring tension pin (16) and remove handle (17).
Remove retaining ring (18), spacer washer (19), handle (20), and spacer washer (21).
Remove two socket-head screws (22) from front of upper guard (23).
Remove three socket-head screws (24) from inside of O/S plate into feeder end of upper
guard (23).
Loosen brake slotted adjusting screw (25).
Remove three socket-head screws (26) from inside of O/S side plate into delivery end of
upper guard (23).
Remove upper guard (23).
2-74