TM 5-3610-286-20
2-18.
Upper Guard and Accessories (Operator Side) (cont).
b. Repair. (figure 2-16)
(1) Remove two hex nuts (1) and handle (2). Replace damaged handle.
(2) Remove two hex nuts (3) and plexiglass cover (4). Replace broken glass cover.
(3) Replace plexiglass cover (4) and two hex nuts (3).
(4) Replace handle (2) and two hex nuts (1).
Figure 2-16. Upper Guard Repair.
c. Install. (figure 2-17)
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
Apply light machine oil to mating surface of upper guard (1) and replace guard on press.
Install three socket-head screws (2) through O/S side plate into delivery end of upper
guard (1).
Tighten slotted brake adjusting screw (3).
Install three socket-head screws (4) through O/S plate into feeder end of upper
guard (1).
Install two socket-head screws (5) through front of upper guard (1).
Install spacer washer (6), handle (7), spacer washer (8), and retaining ring (9).
Install handle (10) and drive in spring tension pin (11).
Install handle (12) and tighten hex nut (13).
Install stud and compression spring (14), handle (15), and drive in spring tension
pin (16).
2-76
