TM 5-3610-286-10
2-7.
OPERATING PROCEDURES (CONT)
c. Prepare Cylinder Assembly (Cont)
WARNING
EXPOSED MOVING PARTS.
All adjustments will be made
while Printing Press is on SAFETY STOP except those
authorized by this manual to be made with Printing
Press running.
Printing Press must be on safe at all
times when not in motion. Always shout “clear” and
wait for “clear” response before taking Printing
Press off safe to inch or run. Failure to follow
this warning may result in serious injury.
(b) Take Printing Press off safe and inch until gripper clamp is
accessible.
(c) Put Printing Press on safe.
Insert plate into gripper clamp.
Ensure register marks aline with scale at each end of clamp.
(d) Lock gripper clamp with plate wrench.
(e) Insert packing behind plate flush against gripper clamp with
elongated slots alined with register scopes.
(f) Take Printing Press off safe.
Hold tail edge of plate back and
inch Printing Press until tail clamp is positioned to allow buckle of plate
to hold plate in clamp after insertion.
2-62
