TM 5-3610-286-10
2-7.
OPERATING PROCEDURES (CONT)
d.
Prepare Dampening Assembly
INITIAL SETUP
Tools
19 mm T-handle socket wrench (appendix B, section III, item 44)
0.10 mm feeler gage (appendix B, section III, item 12)
Curved pin wrench (appendix B, section III, item 41)
10 mm open-end wrench (appendix B, section III, item 40)
13 and 17 mm combination wrench (appendix B, section III, item 40)
Long-handle flat-tip screwdriver (appendix B, section III, item 32)
Materials
Paper strips
Fountain solution (appendix D, item 54)
Water
General Safety Instructions
WARNING
l EXPOSED MOVING PARTS.
All adjustments will be made while
Printing Press is on SAFETY STOP except those authorized by
this manual to be made with Printing Press running.
Printing
Press must be on safe at all times when not in motion.
Always shout “clear” and wait for "clear" response before
taking Printing Press off safe to inch or run.
Failure to
follow this warning may result in serious injury.
l EXPOSED MOVING PARTS.
Remove all jewelry. Keep shirts
tucked in, sleeves above elbows, and ties removed.
Failure
to observe these precautions while operating Printing Press
may result in serious injury.
2-65
