TM 5-3610-286-10
2-7.
OPERATING PROCEDURES (CONT)
NOTE
Placement of roller wheels, brush wheels, and cage
balls depends upon sheet size being run. Illustra-
tions above show distribution of components for
largest and smallest sheet sizes that can be run on
this Printing Press. If paper stock is curled, more
wheels may be used to ensure smooth delivery to front
lays.
(h) Put Printing Press on safe.
Set brush wheels (1) to position
just off rear edge of sheet 1/32 to 1/16 in. (0.08 to 0.16 cm) and rotate
brushes to ensure they have light, even tension.
(i) Position roller wheels (2) as needed and check for light, even
tension.
(j) Position cage balls (3) at front outside edge of sheet. Ensure
cages do not touch paper.
(k) Attach offset sheet smoother to side guide rails to help keep
sheets smooth.
2-45
