TM 5-3610-286-10
3-10.
LIFTING SUCKERS MAINTENANCE INSTRUCTIONS (CONT)
INSTALLATION
1.
Replace sucker (5) on lifting sucker (2) and ensure that sucker is in
groove.
2.
Slide lifting sucker (2) and spring (3) onto air tube (4) and past leaf
spring (1).
Ensure that bottom of lifting sucker is parallel to feeder
board.
3-11.
FORWARDING
This task covers:
INITIAL SETUP
Tools
Key, hex, 5
SUCKERS MAINTENANCE INSTRUCTIONS
a. Removal b.
Cleaning c.
Installation
mm (appendix B, section III, item 20)
Materials/Parts
Suckers (2 required)
30 mm rubber (appendix D, item 67)
38 mm rubber (appendix D, item 68)
30 mm plastic (appendix D, item 65)
38 mm plastic (appendix D, item 66)
Tissue paper (appendix D, item 69)
Rag (appendix D, item 54)
General Safety Instructions
l
EXPOSED MOVING PARTS.
All adjustments will be made while
Printing Press is on SAFETY STOP except those authorized by
this manual to be made with Printing Press running.
Printing
Press must be on safe at all times when not in motion.
Always shout "clear" and wait for “clear” response before
taking Printing Press off safe to inch or run.
Failure to
follow this warning may result in serious injury.
l
ELECTRICAL SHOCK.
Static electricity is retained in static
eliminator bar for up to 2 hours after power is turned off.
Touching static eliminator bar while charged may result in
injury from electrical shock.
3-35
