TM 5-3610-286-10
3-9.
SHEET SMOOTHER COMPONENTS MAINTENANCE INSTRUCTIONS (CONT)
INSTALLATION
NOTE
All wheels must ride on feeder tape.
1.
Place guide rail (3) in position on sheet smoother (5) and tighten
thumbscrews (4).
2.
Place wheels (2) onto guide rail (3) and tighten thumbscrews (1).
ADJUSTMENT Refer to para 2-7b (5).
3-10.
LIFTING SUCKERS
This task covers: a.
MAINTENANCE INSTRUCTIONS
Removal b.
Cleaning c.
Installation
INITIAL SETUP
Materials/Parts
Suckers (2 required)
30 mm rubber (appendix D, item 67)
38 mm rubber (appendix D, item 68)
30 mm plastic (appendix D, item 65)
38 mm plastic (appendix D, item 66)
Tissue paper (appendix D, item 69)
Rag (appendix D, item 54)
General Safety Instructions
WARNING
l
EXPOSED MOVING PARTS.
All adjustments will be made while
Printing Press is on SAFETY STOP except those authorized by
this manual to be made with Printing Press running.
Printing
Press must be on safe at all times when not in motion.
Always shout clear and wait for clear response before
taking Printing Press off safe to inch or run.
Failure to
follow this warning may result in serious injury.
l
ELECTRICAL SHOCK.
Static electricity is retained in static
eliminator bar for up to 2 hours after power is turned off.
Touching static eliminator bar while charged may result in
injury from electrical shock.
3-33