TM 5-3610-286-10
3-8.
BLANKET MAINTENANCE INSTRUCTIONS (CONT)
WARNING
EXPOSED MOVING PARTS. All adjustments will be made while
Printing Press is on SAFETY STOP except those authorized by
this manual to be made with Printing Press running.
Printing
Press must be on safe at all times when not in motion.
Always shout "clear” and wait for "clear” response before
taking Printing Press off safe to inch or run.
Failure to
follow this warning may result in serious injury.
NOTE
The following steps are for low spots which are not repaired
by above method or are too big to be repaired by above
method.
2.
Loosen and remove tail edge of blanket.
Take Printing Press off safe
and inch backward until low spot is accessible.
3.
Put Printing Press on safe.
Using felt-tip pen, trace outline of low
spot on back of blanket. Observe pen tip movement from front of blanket.
4.
Prepare patch by tearing tissue or packing paper to fit low spot.
5.
Apply rubber adhesive to patch and attach to low spot outlined on
blanket.
6.
Take Printing Press off safe.
Install blanket and packing. Put
Printing Press on safe.
INSTALLATION Refer to para 2-7c.
3-9.
SHEET SMOOTHER COMPONENTS MAINTENANCE INSTRUCTIONS
This task covers: a. Removal b.
Installation c. Adjustment
INITIAL SETUP
Materials/Parts
Rubber roller wheels (appendix B, section II, item 24)
Steel roller wheels (appendix B, section II, item 25)
Nylon brush wheels (appendix B, section II, item 9)
Horsehair brush wheels (appendix B, section II, item 9)
Cage balls (appendix B, section II, item 1)
3-31
