TM 5-3610-286-10
3-14.
FEEDER TIMING MAINTENANCE INSTRUCTIONS (CONT)
General Safety Instructions
WARNING
EXPOSED MOVING PARTS.
All adjustments will be made while Printing
Press is on SAFETY STOP except those authorized by this manual to
be made with Printing Press running. Printing press must be on
safe at all times when not in motion.
Always shout clear and
wait for clear" response before taking Printing Press off safe to
inch or run.
Failure to follow this warning may result in serious
injury.
1.
Using both wrenches, loosen hex head screws (1).
NOTE
Each line on reference scale moves feeder approximately 1/8
in. (0.32 cm) forward or backward.
ADJUSTMENT
2.
With fingers, move sprocket wheel (2) to desired setting.
3.
Tighten hex head screws (1).
3-40