TM 5-3610-286-10
3-8.
BLANKET MAINTENANCE INSTRUCTIONS (CONT)
5.
Put Printing Press on safe.
blanket bar (1) up and out from
6.
To remove blanket bars from
from each blanket bar.
Grasp blanket on both sides and push
clamps (2).
blanket, remove eight hex head screws (3)
7.
Install blanket cylinder guard.
CLEANING
WARNING
EXPOSED MOVING PARTS.
Do not inch Printing Press and wipe
cylinder at the same time.
Return Printing Press to SAFETY STOP
after each inching.
Failure to do so may result in serious
injury.
Clean blanket with lithographic solvent.
REPAIR
1.
Locate low spot in blanket and soak spot with lithographic regenerator
to remove.
3-30
