TM 5-3610-286-10
2-7. OPERATING PROCEDURES (CONT)
e. Prepare Inking Assembly (Cont)
NOTE
Turning locking knurled adjustment screw to right
will increase pressure and to left will decrease
pressure.
A slight move in either direction may
cause substantial change in pressure.
(f) To adjust, loosen locknut and adjust locking knurled adjustment
screw.
Tighten locknut finger tight.
(g) Repeat steps (a) through (f) above until desired nip line is
obtained.
(21) Install Distributor Roller No. 16 (White)
(a) Grasp handle and pull manual inking roller no. 15 toward
delivery end to disengage.
(b) Insert distributor roller no. 16 into guide brackets above
oscillator roller no. 14.
NOTE
Engaging manual inking roller no. 15 provides
required pressure against distributor roller no. 16.
No further adjustment is necessary.
(c) Move manual inking roller no. 15 toward feeder and press down
on handle to engage.
(22) Install Ductor Roller No. 18 (Blue)
(a) Move ink supply lever to left (on) position. Take Printing
Press off safe and inch forward until ductor roller no. 18 journals have
moved completely toward fountain roller no. 19.
(b) Put Printing Press on safe.
Insert roller bearing into gear
side journal between fountain roller no. 19 and oscillator roller no. 17.
2-88
