OPERATING PROCEDURES (CONT) - TM-5-3610-286-10

OPERATING PROCEDURES (CONT) - TM-5-3610-286-10_122

OPERATING PROCEDURES (CONT) - TM-5-3610-286-10_124

TM-5-3610-286-10 Topographic Support System Press Section Printing Press Model SOR 3610-01-214-1245 Manual
Page Navigation
113

TM 5-3610-286-10 2-7. OPERATING PROCEDURES (CONT) e. Prepare Inking Assembly (Cont) (b) Move pivot latches (1) over roller bearings to lock roller in position. (c) Tighten knurled adjustment screws finger tight. (17) Adjust Rider Roller No. 8 to Distributor Roller No. 7 Turn knurled adjustment screws to right until finger tight. (18) Install Distributor Roller No. 12 (Red) (a) Open safety gate at feeder end. (b) Insert distributor roller no. 12 roller bearings in journals between oscillator rollers no. 6 and no. 14. (19) Install Rider Roller No. 13 (a) Aline flat sides of spindle ends with grooves in journals. (b) Insert roller spindles in journals. (c) Apply light pressure on spindles using locking knurled adjustment screws. Turn locknuts finger tight. (20) Adjust Rider Roller No. 13 to Distributor Roller No. 12 NOTE It may be necessary to add more ink to rollers. (a) Take Printing Press off safe and run until ink smoothes out on rollers. (b) Put Printing Press on safe and let sit for 15 seconds. (c) Take Printing Press off safe and inch until nip line is visible on rider roller no. 13. (d) Put Printing Press on safe. Press a small strip of paper over nip line on rider roller no. 13 approximately 4 in. (10.2 cm) from each end of roller. (e) Remove paper strips and check width of nip line on paper. Nip line should be 1/8 to 3/16 in. (0.32 to 0.48 cm). 2-87

Privacy Statement
Press Release
Contact