TM 5-3610-286-10
2-7.
OPERATING PROCEDURES (CONT)
e. Prepare Inking Assembly (Cont)
(e) Turn worm adjustment screws to left to relieve tension on form
roller no. 4.
(f) Push roller journal shaft completely in.
(g) Using pin wrench, tighten knurled locking nut (1).
(h) Turn worm adjustment screws to right until slight resistance is
felt.
(i) Turn adjustment screws for form roller no. 3 to right until
slight resistance is felt.
(9) Adjust Form Roller No. 3 to Oscillator Roller No. 5
NOTE
Printing Press will not operate with safety gate
open.
(a) Open safety gate on delivery side.
Apply ink across surface of
oscillator roller no. 5. Close safety gate.
(b) Take Printing Press off safe and run until ink smoothes out on
rollers.
(c) Put Printing Press on safe and let sit for 15 seconds.
(d) Take Printing Press off safe and inch forward until nip line is
visible on oscillator roller no. 5.
(e) Put Printing Press on safe.
Press a small strip of paper over
nip line on oscillator roller no. 5 approximately 4 in. (10.2 cm) from each
end of roller.
(f) Remove paper strip and check width of nip line. Nip line width
should be 5/32 in. (0.41 cm).
2-82
