TM 5-3610-286-10
2-7.
OPERATING PROCEDURES (CONT)
d.
Prepare Dampening Assembly (Cont)
(2) Adjust Dampening Form Rollers To Plate
NOTE
Dampening form rollers no. 20 and no. 21 are set to
plate while Printing Press is running. Dampening
form rollers are set properly when leading edge of
plate makes dampening form rollers bounce slightly.
Bounce can be felt at ends of knurled setting collar
shafts while Printing Press
(a) Reinstall cylinder safety guard.
(b) Take Printing Press off safe and
is running.
run.
(c) Set dampening form roller control lever to right (on) position.
(d) Use four knurled setting collars (1) to set dampening form
rollers. Turn right to increase pressure and left to decrease pressure.
(e) Put Printing Press on safe.
2-69
