TM 5-3610-286-10
2-7.
OPERATING PROCEDURES (CONT)
d.
Prepare Dampening Assembly (Cont)
(f) Insert dampening ductor roller no. 23 into journal cup (3) on
drive side, then into journal box on operator side, and lock into place
with adjustment screw (4). Secure locknut (5).
(g) Move
position.
(h) Take
dampening fountain solution supply lever to left (on)
WARNING
EXPOSED MOVING PARTS.
All adjustments will be made
while Printing Press is on SAFETY STOP except those
authorized by this manual to be made with Printing
Press running. Printing Press must be on safe at all
times when not in motion. Always shout “clear” and
wait for **clear** response before taking Printing
Press off safe to inch or run. Failure to follow
this warning may result in serious injury.
Printing Press off safe and inch until dampening ductor
roller no. 23 completes its movement to dampening oscillator roller no. 22.
—
(i) Put Printing Press on safe. Loosen locknuts (6).
(j) Using knurled adjustment nuts (7), adjust dampening ductor
roller no. 23 against dampening oscillator roller no. 22 on operator and
drive sides until slight drag is felt with 0.004 in. (0.10 mm) feeler gage.
(k) Turn knurled adjustment nuts (7) left to decrease pressure and
right to increase pressure.
Tighten locknuts (6).
2-68
