TM 5-3610-286-10
2-7.
OPERATING PROCEDURES (CONT)
e. Prepare Inking Assembly (Cont)
(1) Preparation for Roller Installation
CAUTION
Use roller supports for removed rollers that are not
stored in roller rack.
Failure to do so may damage
roller surface=
(a) Remove rider roller no.
8 by backing off knurled adjustment
screw and lifting roller out.
WARNING
EXPOSED MOVING PARTS.
All adjustments will be made
while Printing Press is on SAFETY STOP except those
authorized by this manual to be made with Printing
press running. Printing Press must be on safe at all
times when not in motion.
Always shout “clear” and
wait for “clear” response before taking Printing
Press off safe to inch or run. Failure to follow
this warning may result in serious injury.
(b) Take Printing Press off safe and inch until oscillator roller
no. 5 is in far left position (drive side) and red mark on roller points
toward delivery end of Printing Press.
2-74
