TM 5-3610-285-14
a.
Turn power switch OFF and unplug power cord.
b.
Remove one screw from each of four clips. Loosen other screws.
c.
Turn clips 90 to left or right.
CAUTION
Glass surface must be handled with care to avoid chipping or breaking.
d.
Remove glass surface and set aside.
e.
Remove seven screws and front cover panel.
f.
Remove washers and bezel nut from power switch.
NOTE
Ground wire is not connected to switch. Mark position for reinstallation.
g.
To remove defective power switch, pull to inside of board. Tag and disconnect wires.
h.
Remove defective switch.
i.
Connect wiring to new power switch and remove tags.
j.
Reinstall washers and bezel nut. Adjust for proper positioning of power switch.
k.
Reinstall front cover panel and secure with seven screws.
l.
Reinstall glass surface.
m.
Turn clips 90 to secure glass surface.
n.
Reinstall screws on clips. Tighten all screws.
o.
Plug in power cord and turn power switch ON.
8-19
