TM 5-3610-285-14
Section V DIRECT/GENERAL SUPPORT MAINTENANCE
7-18. REPAIR PARTS, SPECIAL TOOLS; TEST, MEASUREMENT, AND DIAGNOSTIC EQUIPMENT
(TMDE); AND SUPPORT EQUIPMENT.
7-18.1 Common Tools and Equipment. For authorized common tools and equipment, refer to the Modified Table of
Organization and Equipment (MTOE) applicable to your unit.
7-18.2 Special Tools; Test, Measurement, and Diagnostic Equipment; and Support Equipment. Special Tools, TMDE,
and Support Equipment is listed in the applicable repair parts and special tools list and in Appendix B of this manual.
7-18.3 Repair Parts. Repair parts are listed and illustrated in the Repair Parts and Special Tools. List, TM 5-3610-285-
24P covering direct/general support maintenance for this equipment.
7-19. DIRECT/GENERAL SUPPORT TROUBLESHOOTING PROCEDURES.
a. Direct/general support troubleshooting procedures cover the most common malfunctions that may be repaired
at the direct/general support level. Repair or adjustment requiring specialized equipment is not authorized unless such
equipment is available. Troubleshooting procedures used by lower level maintenance should be conducted in addition to
the direct/general support troubleshooting procedures.
b. This manual cannot list all the possible malfunctions or every possible test/inspection and corrective action. If
a malfunction is not listed or corrected by a listed corrective action, notify your supervisor.
Table
7-4. DIRECT/GENERAL SUPPORT TROUBLESHOOTING
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
1.
DENSITOMETER WILL NOT ENERGIZE.
Step 1. Check for defective power supply board.
(a)
If power supply board not defective, proceed to step 2.
(b)
If power supply board defective, replace power supply board
assembly (paragraph 7-20.4).
7-62
