TM 5-3610-285-14
7-16.18 Aline Reflection Probe Optical System .
MOS: 83FJ6, Reproduction Equipment Repairer
TOOLS:
Tool Kit, Light Machine Repair
Flat Tip Screwdriver
a.
Apply pressure against reflection probe body and probe base, causing body and base to mate in the normal
measurement position.
b.
Check to see that base bottoms-out against probe tip.
c.
If necessary, loosen two base screws and realine.
d.
Place a piece of translucent white paper over target area.
e.
Check to see that a focused rectangular image appears approximately in the center of target area.
f. If necessary, remove probe housing cover and adjust physical position of lamp.
7-59