TM 5-3610-285-14
NOTE
Grasp heating element and support element while removing retaining screws.
d.
Remove two screws from heater mounting brackets on each end of heating element. Gently lower element into
shroud compartment.
e.
Tag wiring and remove nuts and wiring from terminals on end of heater assembly.
f.
Remove socket head screws retaining heater assembly to brackets. Remove heater assembly.
g.
Install new heater assembly to brackets. Retain with socket head screws.
h.
Reinstall wiring to terminals and retain with nuts.
i.
Reinstall brackets and heating element with screws.
j.
Reinstall grille plate and retain with screws.
k.
Reinstall dryer air tubes and dryer rollers (Table 5-1, Item 13).
l.
Turn on processor circuit breaker.
5-157
