TM 5-3610-285-14
NOTE
Grasp heating element and support element while removing retaining screws.
d.
Remove two screws from heater mounting brackets on each end of heating element. Gently lower element into
shroud compartment.
e.
Label and disconnect wiring from thermostat assembly.
f.
Remove screws retaining thermostat assembly to bracket. Remove thermostat assembly.
g.
Install new thermostat assembly to bracket and retain with screws.
h.
Reconnect wiring to thermostat.
i.
Reinstall heating element brackets and retain with screws.
j.
Reinstall grille and retain with screws.
k.
Reinstall dryer air tubes and dryer rollers (Table 5-1, Item 13).
l.
Turn on processor circuit breaker.
5-159
