TM 5-3610-285-14
c.
Tag and disconnect wires from both ends of tubular heater.
d.
Loosen three clamps holding tubular heater in place and remove defective tubular heater.
e.
Install and center new tubular heater into housing, and tighten clamps.
CAUTION
Do not overtighten nuts holding wires in place or tubular heater may be damaged.
f.
Reinstall wires to ends of tubular heater. Be sure that a washer is on either side of wire connector.
g.
Reinstall blowers/heater housing front cover panel.
h.
Plug in power cord.
3-29