TM 5-3610-285-14
3-16. MAINTENANCE PROCEDURES.
a.
This section contains instructions covering organizational maintenance functions for the plate finishing table.
Personnel required are listed only if the task requires more than one.
b.
After completing each maintenance procedure, perform operational check to be sure that equipment is properly
functioning.
INDEX
PROCEDURES
PARAGRAPH
Replace Blowers/Heater Switch................................................................................................................3-16.1
Replace Pilot Light(s) ...............................................................................................................................3-16.2
Replace Tubular Heater ...........................................................................................................................3-16.3
Replace Pancake Blower(s) .....................................................................................................................3-16.4
Replace Power Cord ................................................................................................................................3-16.5
Remove/Install Plate Finishing Table .......................................................................................................3-16.6
3-16.1 Replace Blowers/Heater Switch.
MOS: 83FJ6, Reproduction Equipment Repairer
TOOLS:
Tool Kit, Light Machine Repair
Flat Tip Screwdriver
Pliers
SUPPLIES: Switch
WARNING
Death or serious injury may occur from electrical shock unless power cord is unplugged before servicing.
a.
Unplug power cord.
3-24
