TM 5-3610-285-14
Section III. OPERATOR MAINTENANCE
3-8. LUBRICATION INSTRUCTIONS . This equipment does not require lubrication at the operator level of
maintenance.
3-9. TROUBLESHOOTING PROCEDURES.
a.
The table lists the common malfunctions which you may find during the operation or maintenance of the plate
finishing table, or its components. You should perform the test/inspections and corrective actions in the order listed.
b.
This manual cannot list all malfunctions that may occur, nor all test or inspections and corrective actions. If a
malfunction is not listed or is not corrected by listed corrective actions, notify your supervisor.
Table 3-2. TROUBLESHOOTING
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
1.
PLATE FINISHING TABLE WILL NOT ENERGIZE.
Step 1.
Check that power cord is plugged in.
(a)
If power cord is plugged in, proceed to step 2.
(b)
Plug in power cord.
Step 2.
Check position of power panel circuit breaker.
(a)
Reset circuit breaker.
(b)
If problem persists, notify your supervisor.
3-10. MAINTENANCE PROCEDURES.
a.
This section contains instructions covering operator maintenance functions for the plate finishing table.
Personnel required are listed only if the task requires more than one.
b.
After completing each maintenance procedure, perform operational check to be sure that equipment is properly
functioning.
INDEX
PROCEDURE
PARAGRAPH
Replace Kraft Paper Roll.....................................................................................................................
3-10.1
3-12
