TM 5-3610-285-14
f.
Carefully reinstall blowers and blower mounting plate so that blowers' exhausts fit through portal holes of
frame. Aline all screw holes on top.
g.
Reinstall six screws and pencil tray to blowers/heater housing.
h.
Reinstall fourteen screws and front cover plate to housing.
i.
Plug in power cord.
j.
Place blowers/heater switch to left and allow blowers to run for one minute.
k.
Place blowers/heater switch to center position.
l.
Unplug power cord.
3-12. REPAIR PARTS, SPECIAL TOOLS; TEST, MEASUREMENT, AND DIAGNOSTIC EQUIPMENT (TMDE); AND
SUPPORT EQUIPMENT.
3-12.1 Common Tools and Equipment. For authorized common tools and equipment, refer to the Modified Table of
Organization and Equipment (MTOE) applicable to your unit.
3-12.2 Special Tools; Test, Measurement, and Diagnostic Equipment; and Support Equipment. Special Tools, TMDE,
and Support Equipment is listed in the applicable repair parts and special. tools list and in Appendix B of this manual.
3-12.3 Repair Parts. Repair parts are listed and illustrated in the Repair Parts and Special Tools List, TM 5-3610-285-
24P covering organizational maintenance for this equipment.
3-13. SERVICE UPON RECEIPT.
3-13.1 Check Unpacked Equipment.
a.
Inspect the equipment for damage incurred during shipment. If equipment has been damaged, report the
damage on DD form 6, Packing Improvement Report.
b.
Check the equipment against the packing list to see if the shipment is complete. Report all discrepancies in
accordance with the instructions of DA Pam 738-750.
c.
Check to see whether the equipment has been modified.
3-17
