TM 5-3610-257-14
Table 6-3. ORGANIZATIONAL PREVENTIVE MAINTENANCE CHECKS AND SERVICES - Cont
B- Before
W- Weekly
AN - Annually
(Number) - Hundreds of Hours
D - During
M - Monthly
S - Semiannually
A - After
Q - Quarterly
BI - Biennially
IN
ITEM TER
ITEM TO BE INSPECTED
NO.
VAL
PROCEDURES
FILM DRYER - Cont
1
S
Service Film Dryer - Cont
NOTE
Before removing gears, note location of metal gear. It must be reinstalled on the same air
tube.
8.
Remove five gears and two brass washers from bottom roller assembly. Visually inspect and
replace if necessary.
9.
Remove three gears from upper roller assembly. Visually inspect for wear and replace if
necessary.
NOTE
• Mark position of rollers with respect to their locations before disassembly.
• Your machine may contain ty-belts around rollers. That must be cut prior to removing
rollers.
• Before removing side stations, note position and quantities of washers at each end of
roller lid. Be sure quantities are matched on both ends.
CAUTION
Do not attempt to remove air tubes from right side (gear side) station. Damage to the right
side station will occur.
10.
Remove bottom side stations from bottom roller assembly.
Remove top side stations from top roller assembly.
11.
Visually inspect nylon bearings and rubber grommets
in all side stations for wear. Replace if necessary.
NOTE
Your machine may not contain buffer rings or air tube corks. Perform following
procedures accordingly.
6-20
