TM 5-3610-253-14
d. Remove the clamping screw for the yellow cable at the rear of the clamp
pressure adjusting knob.
e.
Pry open the clamp and remove the yellow cable from the clamp.
f. Remove front electronics enclosure cover.
Remove right pillar cover.
g.
h. Remove hydraulic system cover plate.
i.
Remove yellow cable from the top of the inch valve.
Remove clamp piston cover plate.
j.
k. Remove cable holddown inside piston enclosure area.
l.
Cut wire ties as necessary and remove defective yellow cable from frame.
m.
Install new yellow cable into frame so that the top of the cable is near
the clamp pressure adjusting knob, and the bottom is near the inch
valve.
n.
Install cable to inch valve.
o.
Install cable into the clamp and tighten clamp down.
Reinstall cable holddown inside the clamp piston area.
p.
Reinstall top cover.
q.
r.
Reinstall clamp piston cover plate.
s.
Reinstall main motor V-belt cover.
t. Reinstall hydraulic system cover plate.
5-562