TM 5-3610-253-14
Remove the clamping screw for the green cable on the back of the clamp
g.
pressure adjusting knob.
h.
Pry open the clamp and remove the green cable from the clamp.
i.
Cut wire ties as necessary and pull the defective green cable out of the
cutter.
Install new green cable into the clamp so that by rotating the clamp
j.
pressure adjusting knob the cable is activated from a minimum amount to
a maximum amount.
k.
Tighten clamp by reinstalling the clamping screw.
Feed cable down between the frames so that it exits the bottom left side
l.
of the right side and secure in place with wire ties.
m.
Reinstall the top cover and secure with screws and washers.
n.
Reinstall the main drive motor V-belt cover.
o.
Reinstall the green cable onto the mounting bar so that most of the
threads of the cable are on the side that enters the pillar.
Reinstall mounting bracket and secure with bolt.
p.
Reinstall front and rear electronics enclosure covers.
q.
Turn on circuit breaker.
r.
s.
Perform clamp pressure adjustment (paragraph 5-40.56).
5-565
