TM 5-3610-253-14
b.
Remove front electronics enclosure cover.
Remove screws and main drive motor overload relay cover.
c.
d.
Insert flat tip screwdriver into snap release holes, and unsnap plastic
cover.
Loosen and remove retaining screw clamps. Then remove defective relay.
e.
Tag and disconnect wiring from relay.
f.
Remove defective relay from plastic frame by pressing in on tabs.
g.
Reconnect wiring onto new relay.
h.
i.
Insert new relay into frame and press down until both tabs snap.
Reinstall plastic frame into mounting frame and secure with screw
j.
clamps.
Reinstall plastic cover over relay.
k.
l.
Reinstall overload relay cover and retain with screws.
m.
Reinstall front electronics enclosure cover.
n.
Place operator key back into safety lock.
5-421
