TM 5-3610-253-14
(3) Press control power on switch.
h. Place table lamp switch to the right.
i.
Loosen locknut on mounting rod for new OCL lamp and adjust mounting
rod until cutting line is bright and sharp. Tighten locknut.
Turn off power.
j.
(1) Turn Star-Delta switch to Y position, then to O position.
(2) Turn main power switch to O position.
ORGANIZATIONAL MAINTENANCE
Section IX
LUBRICATION INSTRUCTIONS.
5-31.1 Hard time intervals and the related man-hour times are based on normal
operation. The man-hour time specified is the time you need to do all the services
prescribed for a particular interval. Change the interval if your lubricants are
contaminated or if you are operating the equipment under adverse operating condi-
tions, including longer-than-usual operating hours. The interval may be extended
during periods of low activity. If an extended period of low activity is
anticipated, adequate preservation precautions must be taken.
5-31.2 On-condition (OC) intervals for oil changes shall be determined by the Army
Oil Analysis Program (AOAP) laboratory and shall be applied unless otherwise noti-
fied.