TM 5-3610-253-14
Table 5-19. TROUBLESHOOTING - Cont
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
14. MEASURED BACKGAUGE POSITION AND MEASUREMENT DISPLAY ARE NOT IN AGREEMENT.
ADJUSTMENT DOES NOT CORRECT PROBLEM, OR BACKGAUGE POSITION DOES NOT STAY SET.
Check backgauge guiding rails for dirt or dryness.
(a) If guiding rails are dirty or dry, clean and oil backgauge
rails (paragraph 5-31.).
(b) If malfunction persists, refer to direct/general support
maintenance.
5-30. MAINTENANCE PROCEDURES.
a. This section contains instructions covering operator maintenance functions for
the paper cutter. Personnel required are listed only if the task requires more than
one.
b. After completing each maintenance procedure, perform operational check to be
sure that equipment is properly functioning.
INDEX
PROCEDURES
PARAGRAPH
Rotate or Replace Cutting Stick . . . . . . . . . . . . . . . . . . . . 5-30.1
Replace Fluorescent Lamp or Starter . . . . . . . . . . . . . . . . . . 5-30.2
Replace OCL Lamp(s) . . . . . . . . . . . . . . . . . . . . . . . . . . 5-30.3
