TM 5-3610-253-14
Retain with screws but do not tighten.
f. Install new switch.
Reconnect wiring in proper positions.
g.
h. Adjust gear limit switches as follows:
(1) Perform manual knife carrier movements, paragraph 5-16.27 steps b.
through h. to ensure that knife is at highest position.
(2) On limit switch labeled "B", adjust limit switch so that maximum
movement left in the activation of the switch is 0.30 mm (.011
in.); then tighten mounting screws.
(3) Rotate reset handles so that limit switch labeled "A" is fully
activated by the cam (this step lowers knife carrier to its lowest
position).
(4) Adjust limit switch so that maximum movement left in the activa-
tion of the switch is 0.30 mm (.011 in.); then tighten mounting
screws.
(5) Perform manual knife carrier movements, paragraph 5-16.27, steps b
through m to ensure that knife is at highest position.
Reinstall cover to gear limit switches.
i.
Place operator key back into safety lock.
j.
5-181
