TM 5-3610-253-14
(5) Rotate adjustment nuts individually until beam is centered on
detector in opposite light barrier housing.
(6) Adjust each emitter bulb in accordance with steps (4) and (5)
above.
NOTE
If all lamps are properly adjusted; signal lamp will be on until beam is
broken.
(7) Turn main power switch to 0 position, and proceed to next step.
Reinstall emitter cover and retain with screws.
j.
k. Place operator key back into safety lock.
Repair Right Light Barrier Assembly.
MOS: 83FJ6, Reproduction Equipment Repairer
TOOLS: Flat Tip Screwdriver
SUPPLIES: Photo Element Board
Lamp Lens
Signal Lamp
WARNING
Death or serious injury may occur from electrical shock unless power is
turned off before servicing.
a.
Turn off power.
(1) Turn main power switch to 0 position.
(2) Using operator key, lock safety lock and keep key in your
b. Remove screws holding right light barrier cover panel in place and
remove cover.
To replace signal lamp, proceed to step g.
c.
d. To replace photo element board, proceed to step f.
To replace lens, proceed as follows:
e.
5-186
