TM 5-3610-253-14
Section V DIRECT/GENERAL SUPPORT MAINTENANCE
4-18. REPAIR PARTS, SPECIAL TOOLS; TEST, MEASUREMENT, AND DIAGNOSTIC EQUIPMENT
(TMDE); AND SUPPORT EQUIPMENT.
4-18.1 Common Tools and Equipment. For authorized common tools and equipment,
refer to the Modified Table of Organization and Equipment (MTOE) applicable to your
unit.
4-18.2 Special Tools: Test, Measurement, and Diagnostic Equipment; and Support
Equipment. Special Tools, TMDE, and Support Equipment is listed in the applicable
repair parts and special tools list and in Appendix B of this manual.
4-18.3 Repair Parts. Repair parts are listed and illustrated in the Repair Parts
and Special Tools List, TM 5-361O-253-24P covering direct/general support maintenance
for this equipment.
DIRECT/GENERAL SUPPORT TROUBLESHOOTING PROCEDURES.
Direct/general support troubleshooting procedures cover the most common malfunctions
that may be repaired at the direct/general support level. Repair or adjustment
requiring specialized equipment is not authorized unless such equipment is avail-
able. Troubleshooting procedures used by lower level maintenance should be conduc-
ted in addition to the direct/general support troubleshooting procedures.
Table 4-3. DIRECT/GENERAL SUPPORT TROUBLESHOOTING
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
CUTTING BLADES DO NOT ROTATE.
1.
Step 1.
Check safety cover switch with multimeter.
(a) If continuity exists, proceed to step 2.
(b) If continuity does not exist, replace safety cover switch
Check key switch.
Step 2.
(a) If key switch operates properly, proceed to step 3.
(b) Replace key switch (paragraph 4-20.1).
