TM 5-3610-253-14
3-10.6 Adjust Supporter Spring.
MOS: 83F, Photolithographer
TOOLS: Needle Nose Pliers
WARNING
Death or serious injury may occur from electrical shock unless power cord
is unplugged before servicing.
a.
Unplug power cord.
b. Pull supporter spring rod free from back of supporter.
c.
Remove cotter pin from supporter spring rod.
d. Slide supporter spring up rod until next hole is visible and reinstall
cotter pin.
NOTE
If cotter pin was removed from the uppermost of four holes in the
rod, replace spring (paragraph 3-10.4).
e.
Engage supporter spring rod on supporter.
f. Plug in power cord.
3-40
