TM 5-2330-305-14
5.3.2.5 REPLACE BEARING/SEALS.
TOOLS :
Wrench Set
Flat-Tipped Screwdriver (1/4 in.)
Slip Joint Pliers
Bearing Puller
SUPPLIES: Bearing Cup
Bearing
Wheel Seal
Cotter Pin
Cap O-Ring
1. Remove hub/drum assembly. (5.3.2.6)
2. Pry rear seal out of rear of hub/drum assembly. Remove bearing
washer.
3. Slide bearings out both ends of hub/drum assembly. Drive out old
bearing cups.
4. Place a coat of oil over new bearings and bearing cups.
5. Press on bearing cups in each end of assembly. Insert bearings.
6. Press new rear seal into rear of assembly, in front of bearing.
5-15
