TM 5-2330-305-14
11. Slide new rear seal into rear of asseambly.
12.
Slide new hub/drum assembly and bearings onto axle shaft.
13. Slide on bearing washer.
14. Screw axle nut on shaft until the first few threads have engaged.
Spin wheel left while holding axle nut stationary. Spin wheel until
nut is completely on shaft and wheel cannot be spun anymore. Back
axle nut off 1/4 turn.
15. Insert new cotter pin and fasten.
16. Place new O-ring and axle cap on end of shaft.
17. Fill bearing cavity and cap with oil up to the full mark.
18. Put center plug into cap.
19. Replace wheel.
20. Remove brake spring cage.
5.3.2.7 REPLACE AIR TANK.
TOOLS: Combination Wench (9/16 in.)
Reservoir
SUPPLIES: Thread Sealant (TFL)
1.
2.
3.
4.
5.
6.
7.
8.
Liquid Detergent
Plastic Pail
Cotton Cloth
Solvent
Air Tank
Remove van body.
Repressurize air system by opening moisture ejector.
Remove relay quick release valve (4.4.1.3).
Remove ratio relay valve (4.4.1.2).
Loosen fitting and remove air hose.
Remove four nuts, bolts and washers retainiq tank to frame
brackets.
Remove moisture ejector from bottom of tank.
Remove tank from frame brackets.
9.
Install new tank to frame brackets.
5-18
