TM 5-2330-305-14
3. Drain oil from axle bearing.
If wheel has hubodometer mounted, re-
move hubodometer housing.
4. Pull off hub cap and O-ring.
5. Remove cotter pin in end of axle shaft.
NOTE
Axle nut has left-hand threads.
6. Remove axle nut and bearing washer.
7. Slide hub/drum assembly off axle.
8. Pry rear seal out of rear of assembly.
9. Slide bearings out ends of old hub/drum assembly. Inspect for pits,
cavities, scratches or other signs of wear. Replace bearings are
worn.
10. Slide bearings into cups in new hub/drum assembly. If bearings are
new, put a thin coat of oil on bearing before inserting.
5-17
