TM 5-2330-305-14
7. Slide
8. Slide
9. Screw
CAUTION
DO NOT PRESS (ON OR PRY NEW SEAL
WITH SHARP OR POINTED TOOLS TO
PREVENT DAMAGE TO SEAL.
hub/drum assembly onto axle shaft.
on bearing washer.
axle nut onto shaft until first few threads engage. While
holding axle nut immobile, spin wheel left. Spin wheel until axle
nut is screwed completely on shaft and wheel cannot be spun any more.
Back axle nut off 1/4 turn.
10. Insert new cotter pin and fasten.
11. Place new O-ring and axle cap on end of shaft.
12. Fill bearing cavity and cap with oil up to fill mark.
13. Put center plug in cap.
5.3.2.6 REPLACE HUB/DRUM ASSEMBLY.
TOOLS: Wrench Set
Flat-Tipped Screwdriver (1/4 in.)
Slip-Joint Pliers
Bearing Puller
SUPPLIES: Hub/Drum
Bearing Cup
Bearing
Wheel Seal
Cotter Pin
Cap O-Ring
ENSURE THAT CHASSIS IS PARKED ON LEVEL GROUND.
CAUTION
ENSURE THAT BRAKE SPRING IS CAGED
OR DAMAGE TO EQUIPMENT WILL RESULT.
1. Remove wheel.
(4.4.1.1)
2. Cage spring brake chamber. (4.4.1.5)
5-16
