TB 1-4920-443-35
AEDATS IV T700 ALIGNMENT WORKSHEET
(e) MT-16, 0-50 psig, Dyno lube inlet pressure
(Refer to pages 38 step 42)
1 Using the pressure calibrator, apply the following pressures to MT-16 (PT408) and record the
results. NOTE: Calibrate 5 PS Alarm in conjunction with MT-16.
Vertical Scale
Pressure
Actual
AEDATS 4
Vertical Scale
bottom row 11
(psid)
Pressure
(pdyn_Sup)
+/- 2 psi
+/- 1 Psi
Vent
____________
____________
____________
10
____________
____________
____________
20
____________
____________
____________
30
____________
____________
____________
40
____________
____________
____________
50
____________
____________
____________
R-cal
____________
Transducer: T34
Hardware Name: HL13
(f) Fault light panel
(Refer to page 73 step 57)
(g) J BOX
1 T-700 dyno low oil press fwd
_______ 5 PS set 10.5 psig on decreasing pressure. (+/-
.5)
T-700 dyno low oil press aft
_______ 6 PS set 10.5 psig on decreasing pressure. (+/-
2
.5)
T-700 engine low oil pressure switch _______ 3PS set 25 psig on decreasing pressure. (+/-
3
2)
(h) Fuel Skid
1 T-700 fuel boost
_______11 PS set 15 PSI on increasing pressure (+/- 2)
T-700 skid low fuel level
_______ TB 206, jumper # 11 & 12
2
T-700 skid fuel filter bypass
_______ TB 207 jumper # 1 & 2
3
T-700 fuel valve
_______ Turn on CB305 and fuel pump switch on.
4
Main fuel valve
_______ Turn on CB305 and fuel pump switch.
5
(i) T700 Test Trailer
1 T-700 dynolube filter bypass
_______ J73 connector, jumper pins L & K
T-700 dynolube tank low level
_______ J73 connector, jumper pins M & N
2
T-700 eng Lube Filter Bypass
_______ E-3 connector, jumper pins 13 & 14
3
T-700 Engine fuel filter bypass
_______ E-3 connector, jumper pins 15 & 16
4
T-700 chip detector
_______ E-3 connector, jumper pins 11 & 12
5
T-700 low fuel pressure
_______ E-3 connector, jumper pins 23 & 24
6
156
