TB 1-4920-443-35
AEDATS II T53 ALIGNMENT WORKSHEET
(14)T53/T55/T63 Fault light panel
(Refer to page 75 step 58)
(a) J BOX
1 Dyno low oil pressure fwd
______17PS Set at 10.5 psig on decreasing pressure +/-.5
Fuel pressure
_______18PS Set at 8 psig on decreasing pressure +/-1
2
Low oil pressure Eng
_______15PS Set at 25 on decreasing pressure +/-1
3
Dyno low oil pressure aft
_______16PS Set at 10.5 psig on decreasing pressure+/-.5
4
Anti Ice Pressure
_______13PS Set at 4 psig on increase +/-.5 (touch screen)
5
(b) T53/T55/T63 Test Trailer
1 Chip detector
_______Touch chip detector lead to ground
Dyno supply low pressure
_______19PS on trailer set at 10 psig on DEC. press +/-1
2
Dynolube filter delta-p
_______18PS on trailer set at 10 psig on INC. press +/-1
3
Dynolube tank low level
_______Jumper pins F & G at J103 aux. J-box
4
T55 low oil level
_______Jumper pin A to ground T55 flight harness
5
(c) Fuel Skid
1 Fuel boost pressure
_______ 2 PS set 15 psi on increasing pressure +/-1
T-53/T63 oil filter delta-p
_______ 10PS low side vented pressure high side +/-1
2
set 7 psi on increasing pressure
T-53/T63 low oil level
_______Jumper pins 5 and 6 0n TB 206
3
Main Fuel valve closed
_______Turn on CB305 Press fuel pump switch on
4
Fuel valve select
_______Turn on CB305 and fuel pump switch
5
(d) PT-101,
0-50 in-hg abs, Barometer
(Refer to page 46 step 45)
1 Locate PT-101 on the bell mouth and barometer panel in cabinet 10. Connect the low
pressure calibrator directly to the transducer. Apply following pressures and record the
results. (2.036)
2 Do not zero barometer only set span
Vertical Scale bottom row 9
AEDATS 2
5SE01313-22
Actual
AEDATS 2
6SE00950-28
Vertical Scale Channel name
Pressure
Pressure
(*)
(*)
(in-hg abs)
psi
+/- .05 psi
+/- 0.25 psi
T53 Baro
+3
____________
____________
____________
T55 Baro
Vent
____________
____________
____________
T63 Baro
-3
____________
____________
____________
L714 Baro
R-cal
____________
134
