TM
9-4931-436-14&P
aap. Cable Assembly W7 Replacement
M1
(34)
Fl
(38)
S1
(32)
BT 1 (52)
(1) Plug W7 (67) connector J9 into
S2
(32)
BT 2 (52)
PWB A2 (25).
S3
(32)
BT 3 (52)
(2) Plug W7 connector Jl into PWB
S4
(33)
A6.
(3) Replace cable ties.
(3) Remove six screws (53, 58),
(4) Replace panel assembly (refer
flat washers (2, 36), and four nuts
(50) from cable clamps (71).
aaq. Cable Assembly W8 Removal (fig.
(4) Remove cable ties.
aav. Cable Assembly Wl0 Replacement
(1) Remove panel assembly (refer
(2) Unplug W8 (66) connector J10
(25 watts). Solder two Wl0 (74) wires
from PWB A2 (25).
to each of the following locations:
(3) Unplug W8 connector Jl from
PWB A7.
F1
M1
(34)
(38)
(4) Cut cable ties to release
S1
(32)
BT 1 (52)
cable assemblies.
S2
(32)
BT 2 (52)
aar. Cable Assembly W8 Replacement
S3
(32)
BT 3 (52)
S4
(33)
(1) Plug W8 (66) connector Jl into
PWB
A7.
(2) Install six screws (53, 58),
(2) Plug W8 connector J10 into FWB
flat washers (2, 36), and four nuts
A2 (25).
(50) on cable clamps (71).
(3) Replace cable ties.
(3) Replace cable ties.
(4) Replace panel assembly (refer
(4) Replace panel assembly (refer
aas. Cable Assembly W9 Removal (fig.
aaw. Transistor Ql Removal (fig.
(1) Remove panel assembly (refer
(1) Remove panel assembly (refer
(2) Unplug W9 (63) connector J15
from PWB A2 (25).
(25 watts). Unsolder and tag three
wires from PWB A3 (31) at E1, E2, and
(3) Unplug W9 connector J14 from
PWB A3 (31).
E3.
(3) Remove Q1 (27) from heat sink
(4) Cut cable ties to release
cable assemblies.
(29).
aax. Transistor Q1 Replacement (fig.
aat. Cable Assembly W9 Replacement
(1) Install Ql (27) in heat sink
(1) Plug W9 (63) connector J14
into A3 (31).
(29).
(2) Plug W9 connector J15 into PWB
a grounded soldering iron (25 watts).
A2 (25).
Solder three wires to PWB A3 (31) at
(3) Replace cable ties.
(4) Replace panel assembly (refer
E1, E2, and E3.
(3) Replace panel assembly (refer
aau. Cable Assembly WlO Removal (fig.
(1) Remove panel assembly (refer
(1) Remove panel assembly (refer
(25 watts). Unsolder two Wl0 (76) wires
(25 watts). Solder and tag 3 wires
from each of the following locations:
from PWB A3 (31) at E1, E2, and E3.
6-13