TM 5-6675-328-14
(7)
Select an area as close to power entry as possible to install ground rod. Then assemble the first ground rod
and coupling to the slide hammer rod.
CAUTION
Do not allow ground rod to rotate when removing the slide hammer rod. Rods must be kept screwed
together to make a good electrical ground.
NOTE
Before driving ground rod be certain that rods meet inside coupling. Be sure coupling is handtight against
collar.
(8)
Place slide hammer on hammer rod end, and drive ground rod into ground. Remove slide hammer rod.
Thread new sections, attach slide hammer rod and repeat procedure until only 12 in. (30.5 cm) of the third section is
above ground.
(9)
Remove slide hammer and hammer rod and place in section.
(10)
Secure ground cable clamp and ground cable to ground rod.
1-30