TM 5-6675-328-14
4-16. MAINTENANCE PROCEDURES.
a.
This section contains instructions covering organizational maintenance functions for the grinder and dust control
assembly. Personnel required are listed only if the task requires more than one.
b.
After completing each maintenance procedure, perform operational check to be sure that equipment is properly
functioning.
INDEX
PROCEDURES
PARAGRAPH
Replace Grinder ............................................................................................................................4-16.1
Replace Dust Control Assembly ....................................................................................................4-16.2
4-16.1 Replace Grinder.
MOS: 41B, Topographic Instrument Repair Specialist
TOOLS: 1/2 in. Combination Wrench
7/16 in. Combination Wrench
SUPPLIES: Grinder
WARNING
Death or serious injury may occur from electrical shock unless power cord is unplugged
before servicing.
4-18