TM 5-6675-328-14
4-16.2 Replace Dust Control Assembly.
MOS: 41B, Topographic Instrument Repair Specialist
TOOLS: 7/16 in. Combination Wrench
7/16 in. Socket, 3/8 in. Drive
1/2 in. Socket, 3/8 in. Drive
1/4 in. Socket, 1/4 in. Drive
3/8 in. Drive Ratchet
1/4 in. Drive Ratchet
SUPPLIES: Dust Control System
WARNING
Death or serious injury may occur due to electrical shock unless power cord is unplugged
before servicing.
a.
Unplug power cord.
b.
Remove nuts, bolts, washers, and shock mounts. Remove grinder and base.
c.
Remove sheet metal screws and top cover.
d.
Remove nuts, bolts, washers, and shock mounts retaining dust control assembly to table. Remove dust control
assembly.
e.
Install new dust control assembly. Retain with nuts, bolts, washers, and shock mounts.
f.
Reinstall top cover and retain with sheet metal screws.
g.
Reinstall grinder and base, and retain with bolts, nuts, washers, and shock mounts.
h.
Plug in power cord.
4-17. PREPARATION FOR STORAGE OR SHIPMENT. Contact your battalion for packing and shipping instructions.
SECTION V DIRECT/GENERAL SUPPORT MAINTENANCE
There are no direct/general support maintenance procedures assigned for this equipment.
4-20
Change 1
