TM 5-6675-328-14
4-10. MAINTENANCE PROCEDURES.
a.
This section contains instructions covering operator maintenance functions for the grinder and dust control
assembly. Personnel required are listed only if the task requires more than one.
b.
After completing each maintenance procedure, perform operational check to be sure that equipment is properly
functioning.
INDEX
PROCEDURES
PARAGRAPH
Replace Filter............................................................................................................................................ 4-10.1
4-10.1 Replace Filter.
MOS: 41B, Topographic Instrument Repair Specialist
SUPPLIES: Filter
a.
Loosen latches and raise top cover.
b.
Lift filter up and out of cabinet.
c.
Install new filter; be sure arrow on filter points to rear of collector.
d.
Lower top cover and close latches.
4-14
