TM 5-6675-328-14
4-6.2 Operating Procedures.
a.
Check that grinder motor electrical connector is plugged into dust control system.
b.
Plug in power cord.
WARNING
Grinding or buffing causes air-borne particles that may enter the eyes. Eye protection is
mandatory when operating this equipment.
c.
Turn on dust control assembly.
d.
Perform grinding and/or polishing operation.
e.
Turn off dust control assembly.
CAUTION
Store attachments separately to prevent damage.
f.
Unplug power cord.
g.
Remove wheel(s) from shaft(s) and store.
4-10
