Replace Latch (Handle-Type)

Replace Latch (Recessed Cup Type) - Continued

TM-5-6675-326-14 Topographic Support System Synthessis Section Model ADC-TSS-14 NSN: 6675-01-105-5763 Manual
Page Navigation
450

TM5-6675-326-14 11-9.1 Replace Latch (Handle-Type) - Continued d. Remove nut from handle shaft. e. Drive out pin securing retaining bushing to handle shaft, and remove bushing. f . Remove two screws and washers securing handle to door. Remove handle. INSTALLATION: a. Install new handle, and secure with two screws and washers. b . R e i n s t a l l r e t a i n i n g b u s h i n g w i t h p i n . c . R e i n s t a l l n u t. d . R e i n s t a l l s i d e l a t c h p l a t e . e. Reinstall latch rods and holding plates. f . R e i n s t a l l n u t o n h o l d i n g p l a t e. 11-9.2 Replace Latch (Recessed Cup-Type) PERSONNEL REQUIRED: 1 Topographic instrument repair specialist MOS 41B TOOLS: 9 / 6 4 i n . f l a t - t i p s c r e w d r i v e r 9/16 in. wrench MATERIALS/PARTS: Cup-type latch 11-6

Privacy Statement
Press Release
Contact