TM5-6675-326-14
1 1 - 2 . 1 1 F o l d i n g C h a i r.
Provided for general seating.
F o l d s f l a t f o r
s t o r a g e . D i m e n s i o n s:
Width
18 in. (45.72 cm)
Depth
20 in. (50.80 cm)
H e i g ht
32 in. (81.28 cm)
S e c t i o n I I.
OPERATING INSTRUCTIONS
There are no operating instructions for the furniture and cabinets.
Section III. OPERATOR MAINTENANCE
11-3 LUBRICATION INSTRUCTIONS.
This equipment does not require lubrication.
11-4 OPERATOR TROUBLESHOOTING PROCEDURES.
There are no operator troubleshooting procedures for the furniture
and cabinets.
11-5 OPERATOR MAINTENANCE PROCEDURES.
Inspect cabinets and furniture for structural damage, rust, and
proper operation of all latches, hinges, and adjustment mechanisms.
Section IV. ORGANIZATIONAL MAINTENANCE
11-6 REPAIR PARTS; SPECIAL TOOLS; TEST, MEASUREMENT, AND DIAGNOSTIC
EQUIPMENT (TMDE); AND SUPPORT EQUIPMENT.
11-6.1 For authorized common tools and equipment, refer to the Modified
Table of Organization and Equipment (MTOE) applicable to your unit.
11-6.2 Special tools, TMDE, and support equipment used on your equipment
are listed in the applicable Repair Parts and Special Tools List and in
appendix B of this manual.
1 1 - 6 . 3 R e p a i r p a r t s a r e l i s t e d a n d i l l u s t r a t e d i n t h e r e p a i r p a r t s a n d
special tools list (TM5-6675-326-24P) covering organizational maintenance
for this equipment.
11-7 ORGANIZATIONAL PREVENTIVE MAINTENANCE CHECKS AND SERVICES (PMCS).
There are no PMCS at the organizational level for the furniture and
c a b i n e t s.
11-4
